Decoration Decoration Quality Can Not Be Ignored The Most Common Paint Problems
Interior painting is an important part, likely to have some difficult issues, people do nothing. In fact, as long as the real cause of problems to find the right remedy, it is not difficult to have satisfactory results, the following is easy to produce for paint problems, propose solutions, so you can be more handy when interior decorating.
Paint peeling May cause the surface is too smooth. If the original Paint Is a bright or matte paint (plus untreated paste Paint ), New paint on the surface of the stick is not strong. Or may be rotten wood or metal with rust, but also because of poor quality and peeling paint. Small area of paint peeling off, can be the first to use fine sandpaper, and then cast Putty , Brush on the primer, and then re-painting. Large areas of peeling paint must be scraped all the re-brushing.
Blistering paint First, the bubble burst, if the water emitted, it is clear under paint or moisture infiltration behind by sun drying, the moisture evaporated into steam, it will play into the bubble to the top of patent leather. At this point, first with a blistering hot air gun to remove paint, so that wood naturally dried, and then brush on the primer, and finally re-painting the entire repair surface. If the bubble in the water, it could be wood cracking, a small amount of air, sun drying, air expansion, patent leather to muster up. Faced with this situation, first scrape paint from blistering, and then fill the crack filler resin, re-painting, or do not fill in the scrape patent leather, direct coated microporous paint.
Cracks This most chemical paint remover or use hot air gun to remove paint, then re-painting. If the range is not broken, then used wet or dry sanding block or sandpaper cleaning the bathroom, breaking the paint wore off, the smooth polished surface, the smeared putty, brush on a primer, and re-painting.
Paint flow Paint brushes have a thick, that will cause flow (HotTag) drip. Can not take advantage of paint dry, brush the paint brush to open, if the paint has begun to dry, they should let it dry, use fine sandpaper to smooth polished finish, brush the surface clean, then a damp cloth, then re on outer layer of paint, be careful not to brush too thick.
Smirch Paint surface smudge many reasons. For example: milk Glue Paint the walls of water melted material and rust out of paint, steel wool grazed the wall will have rust, walls and other underground pipe leakage appear weak stain.
To prevent blotches, can first brush with aluminum powder in the primer layer, if it has appeared weak stain, latex paint can first remove the smudge Department, brush layer containing aluminum powder primer, then re-painting.
Mildew discoloration This problem mostly occurs in the wet paint surface, such as water vapor condensation in Glass Or metal surfaces often produce brown-black blotches. Fungicide available at this time, according to the instructions deal with moldy parts, to be killed after the mold, clean the surface, and then re-painting.
Lose luster Reason is not on the primer, or primer and paint was dry on the inner bright paint directly on the results was the wood absorb bright paint to lose luster. Bright paint is also a reason for poor quality. With dry and wet sandpaper to wear off the old paint brush to polish the dust off, wipe with a clean wet cloth to the surface, to be dry, then re-brush on the finish. Special attention is the low temperature environment in the paint, dry film, may also lose their luster.
Film wrinkling
Usually caused by the first pass is dry paint brush that is caused by the second over.
I am an expert from China Chemicals Products, usually analyzes all kind of industries situation, such as carbon molecular sieve , molecular sieve ethanol.
Comment on "Decoration Decoration Quality Can Not Be Ignored The Most Common Paint Problems"
| Related News: |
